1. Home
  2. Knowledge Base
  3. DISH Network Technical Support
  4. How do I program a remote to control a second receiver/ reset my remote?

Turn on the receiver. Use the SYSTEM INFO button on the front panel to open the system info screen. NOTE: if there isn’t a SYSTEM INFO button on the front panel of your receiver check your receiver user’s guide. Write down the address shown:_______________________________________
Press and hold the AUX button until all the other mode buttons light up, then let go of the button. The AUX button flashes.
Press the 3 button
Use the NUMBER PAD to enter the address you wrote in step 1
Press POUND(#). The AUX button blinks three times.
Press RECORD to make sure the address in the remote matches the address on the receiver

Was this article helpful?

Related Articles